Introduction
We build UV lamps that are tailor-made for electronics assembly lines. Out here, curing has to be fast and flawless, every single time. These units are built to give you that rock-solid consistency, whether you’re working on a PCB or a tiny micro-component.
Getting Into the Details
Here’s the thing: we don’t just build a lamp, we build the lamp for your process. That means matching the exact footprint and power density you need. We spec these with a standard 400V input, the kind you expect from industrial gear, so it runs steady even when your line voltage wobbles a bit. The 300mm tube length is a smart move, too. It focuses the UV light right where you need it, so you’re not wasting energy and heating up parts you’re not even touching. And the 2500W of power? That’s what gets the job done in seconds. It keeps your cycle times tight, which is exactly what you need when you’re trying to keep the line moving.
What’s Inside
Inside, you’ll find a high-purity quartz tube. It’s tough, handles the shock of rapid on-off cycles without cracking, and lets the UV light pass through cleanly. The internal halogen element gives you a stable light spectrum, and a special coating keeps the intensity consistent over the lamp’s life. We use an R7s connector, too. It’s an industry standard for a reason—makes the lamp a simple drop-in replacement. You wire it once, and it stays put. No fuss.
Real-World Performance
Out on the shop floor, this setup is built to take the daily grind of electronics work. The focused UV and heat can handle those small, dense components without overheating the whole board. And because it’s compact, it slips easily into tight spots. We stand behind the performance with a simple promise: if our custom lamp can’t match the curing power of a big-name brand unit at the same price, we give you your money back. Now, one thing to keep in mind—that 2500W output is powerful, so it needs proper cooling. Just make sure your fixture has the airflow to handle the heat.