We make UV lamps that cure fast—built for the tough, non-negotiable world of industry and medicine. Here’s the heart of it: these lamps are designed to sit inside dental sterilization boxes and deliver a clean, consistent blast of UV. The whole point? Stop cross-infection dead in its tracks, between every single patient.
Power, voltage, and geometry—kept real
Fast curing only works when the UV intensity stays steady. So we match the electrical specs to the chamber, point-for-point. These lamps run on industrial voltages, which means you can wire them straight into your existing setup—no extra transformer, no headache. The tube length is a careful fit: long enough to cover the full reflector path, but short enough to keep the chamber tight and practical. And the wattage? It’s not for showing off. It’s what gives you the UV fluence needed to hit microbial kill targets in minutes, not hours.
Material and design—built to do the job, day after day
We build the UV source on quartz, because it can handle high heat density and transmit the wavelengths you need without softening. Then we coat the quartz to shape the spectral output, focusing the energy where it matters most—on microbial DNA—instead of wasting it as heat. The connector choice is practical, not flashy. An R7s base gives solid contact and repeatable alignment, so the lamp seats squarely every time. That matters when the box is getting cycled all day, and you can’t afford wiggle room.
Dental-ready, repeatable disinfection
Inside a dental sterilization box, this lamp isn’t just a bulb. It’s part of the safety system. The fast-curing profile shortens the cycle, so you can keep moving during the busiest hours. Thanks to the coating and geometry, you get even exposure—no hot spots, no cold zones—so every instrument surface gets the same treatment. One reality check: high-output UV creates heat. Your chamber has to be ventilated the way it was designed, or thermal stress will shorten lamp life. And the best part? This configuration is engineered as a straightforward drop-in replacement for dental-compatible sterilization equipment. So you get repeatable disinfection without reworking your entire workflow.